Requirements at a glance
| Agency | NC State Board of Examiners of Plumbing, Heating and Fire Sprinkler Contractors; exams by PSI |
|---|---|
| Exam | Plumbing, Heating and Fuel Piping Business and Law exam, 1.5 hours, open book (question count and pass score are not published) |
| Books allowed | Board Laws and Rules (2025/2026) and Business and Project Management for Contractors (6th or 7th edition), per the Board's reference list |
| Fees | $150 by examination: $75 Board application plus $75 nonrefundable PSI exam fee (valid one year), per 21 NCAC 50 .1101(c); then the annual license fee ($150 for contractors, .1102) |
Plumbing, heating, fuel piping and fire sprinkler contractor applicants who do not hold an active license with the Board and a passing Business and Law result after August 2003.
Official links
- NC State Board of Examiners of Plumbing, Heating and Fire Sprinkler Contractors (opens in a new tab)
- NC Board: exam information, book list and 2018 code notice (opens in a new tab)
- Schedule with PSI (NC plumbing, heating and fire sprinkler) (opens in a new tab)
- NC Office of State Fire Marshal: code book sales (opens in a new tab)
How to get licensed, step by step
Apply to the Board
Contact the Board (1109 Dresser Court, Raleigh; 919-875-3612) and submit the exam application for your license type.
NC State Board of Examiners of Plumbing, Heating and Fire Sprinkler Contractors (opens in a new tab)
Wait for PSI's email
Once approved you get an email confirmation from PSI, then register and pay the $75 exam fee (the $75 application fee goes to the Board). After you pass, pay the license fee ($150 a year for contractors) within 45 days.
Schedule with PSI (NC plumbing, heating and fire sprinkler) (opens in a new tab)
Check your book list
Only the books for your exam category are allowed in the room. The Board's list is effective July 1, 2025; confirm it before you buy.
NC Board: exam information, book list and 2018 code notice (opens in a new tab)NC Office of State Fire Marshal: code book sales (opens in a new tab)
Take the exam and Business and Law
Business and Law is a separate Board exam unless you hold an active license and passed it after August 2003.
Schedule with PSI (NC plumbing, heating and fire sprinkler) (opens in a new tab)
How to prepare
- North Carolina's exams use the 2018 NC State Building Code (2015 ICC base text with NC amendments, effective 2019). The 2024 NC codes are delayed to no earlier than May 1, 2027, so use the 2018 books.
- Tab your books with permanent tabs before exam day. Highlighting is allowed; writing, sticky flags and loose papers are not.
- Read G.S. 87 Article 2 and 21 NCAC Chapter 50 and tab the licensing and discipline sections.
- The exam is separate from the trade exam and is not required if you hold an active Board license and passed it after August 2003.
- Start with the free questions above to find your weak topics, then drill those first.
- Take at least two full timed simulations before exam day. Timing is where most people fail open-book exams.
- Read every explanation, including for questions you got right, and look the section up in your own book.
Books for this exam
This is an open-book exam: you can bring the references below. Tabs and highlighting are allowed. Free online copies are read-only and can't be used in the exam room.
2018 North Carolina State Building Code: Administrative Code and Policies
Allowed in the exam room for the general contractor, plumbing and heating exams.
Official reference list (as published by the testing agency)
- NC State Board of Examiners of Plumbing, Heating and Fire Sprinkler Contractors: Laws and Rules, 2025/2026 edition
- Business and Project Management for Contractors (6th or 7th edition), as listed on the Board's reference list
- G.S. Chapter 87, Article 2 and 21 NCAC Chapter 50
What's on the exam
Estimated topic weighting. No official breakdown is published:
| Topic | Questions | |
|---|---|---|
| Licensing Law (G.S. 87 Article 2) | 20 | |
| Board Rules (21 NCAC 50) | 20 | |
| Contracts, Bidding and Estimating | 16 | |
| Business Organization and Finance | 14 | |
| Project Management and Scheduling | 12 | |
| Employment, Safety and Insurance | 10 | |
| Liens and Bonds | 8 |
Exam day details
- Administered by PSI Services for the NC State Board of Examiners of Plumbing, Heating and Fire Sprinkler Contractors.
- Fee: $150 for a license by examination (21 NCAC 50 .1101(c)): $75 Board application fee plus $75 nonrefundable exam fee paid to PSI (valid one year). After you pass, pay the annual license fee ($150 for a contractor license, .1102).
- 1.5 hours, open book. The Board does not publish the number of questions, the pass score or a topic outline.
- Not required if you hold a currently active contractor license with the Board and passed the Board's Business and Law exam after August 2003.
- Open book: bring your own reference books in original published condition (hard-, spiral- or ring-bound), only the books listed for your exam. Highlighting and permanent commercial tabs (ICC Turbo Tabs are the only loose inserts) are allowed; writing, underlining, notes and homemade tabs are not. Printed PDFs are not allowed.
- PSI provides pencils, scratch paper, calculators and the NC Heating and Plumbing Figures. Heating candidates bring their own duct calculator.
- You must apply to the Board first; PSI emails you after approval. A license by examination costs $150 ($75 application fee plus a $75 nonrefundable exam fee paid to PSI, valid one year); after you pass, the annual license fee ($150 for contractors) is due within 45 days.
- You cannot retest the same day. Unauthorized materials in the exam room mean a 90-day wait before you can reschedule.
- Business and Law is a separate exam, not required if you hold an active license and passed the Board's Business and Law exam after August 2003.
Note: The Board publishes exam durations and reference books for each exam but not the number of questions, a pass score or a topic outline. The question count, pass score and topic weights on this page are our practice estimates. The Board's note dated June 1, 2026 says exams stay on the 2018 NC codes (including NFPA 13 and 13D 2013 and NFPA 25 2011) until the 2024 codes take effect, no earlier than May 1, 2027.
Frequently asked questions
Who must take the PHFS Business and Law exam?
Contractor applicants who do not hold an active Board license with a passing Business and Law result after August 2003. Ask the Board's Exam Coordinator about the exemption.
How long is it?
The Board lists 1.5 hours. It does not publish the question count or pass score; our 50 questions is a working length.
Is this the same as the General Contractor Business and Law exam?
No. The NC Licensing Board for General Contractors has its own Business and Law exam (40 questions).
Free questions with answers
Show all 10 free questions and answers
A contractor holding only a Heating Group 3 license is asked to install a 20-ton air-circulating system in a single-family detached residence. According to G.S. 87-21(a)(3), which license applies?
Answer: Heating Group 3, because systems in single-family residences fall under Group 3 regardless of size
The last sentences of G.S. 87-21(a)(3) say that systems installed in single-family residences are included under Heating Group 3 regardless of size. The 15-ton line separates Groups 2 and 3 only for other buildings. Group 1 is for steam, vapor and hot water systems, which this is not.
Reference: N.C. General Statutes Chapter 87, Article 2, G.S. 87-21(a)(3)
Under G.S. 87-21(a)(4), a duct-distributed system uses a coil fed with water from a domestic water heater set no higher than 150 degrees F. Who may extend the piping from the valved connections in the domestic hot water system to the coil?
Answer: A plumbing contractor or a Heating Group 1 contractor
G.S. 87-21(a)(4) says that piping from valved connections in the domestic hot water system to the coil requires either a plumbing or a Heating Group 1 license. Installing the coil, ductwork, controls and drains requires Group 1 or Group 3. The Group 3 licensee therefore cannot run that water piping.
Reference: N.C. General Statutes Chapter 87, Article 2, G.S. 87-21(a)(4)
What grade is required to pass an examination given by the Board under 21 NCAC 50 .0305?
Answer: A grade of 70 on a 100-point scale
Rule .0305 says Board examinations are based on a maximum of 100 points and a grade of 70 is required to pass. Under rule .0301(b), contractor applicants (other than fire sprinkler installation and inspection) must pass both the business and law part and the technical part.
Reference: 21 NCAC Chapter 50 (Board rules), 21 NCAC 50 .0305
Under 21 NCAC 50 .0402(a), a licensed contractor must see that a request for final inspection is made within how many days of the system being made operational or placed in service, absent agreement with the owner and the local Code Enforcement official?
Answer: 10 days
Rule .0402(a) requires the contractor to ensure that he, the general contractor or the owner requests final inspection within 10 days of the earlier of the system being made operational or placed in service, absent an agreement with the owner and the local official. The contractor also must see that a permit is obtained before work starts.
Reference: 21 NCAC Chapter 50 (Board rules), 21 NCAC 50 .0402(a)
Under 21 NCAC 50 .0517(c), the holder of a Heating Group 3 Technician license must be what?
Answer: A full-time employee of a Heating Group 3 contractor
Rule .0517 says each technician (Heating Group 1, 2 or 3, plumbing, or fuel piping) must be a full-time employee of a contractor in the matching category. Rule .0403(c) adds that a technician may not contract work based on the technician license.
Reference: 21 NCAC Chapter 50 (Board rules), 21 NCAC 50 .0517(c)
A contractor's direct cost for a job is $50,000, and she wants a 20 percent gross margin (profit as a share of the selling price). What price should she quote?
Answer: $62,500
Margin is a percentage of price, so price = cost / (1 - 0.20) = $50,000 / 0.80 = $62,500; check: $12,500 profit / $62,500 = 20 percent. Marking cost up 20 percent gives $60,000, which is only a 16.7 percent margin. $71,429 divides by 0.70.
Reference: General estimating and contracting practice, Markup versus margin
A subcontract says the subcontractor will be paid only if and when the owner pays the general contractor. Under G.S. 22C-2, what is the effect of that clause?
Answer: It is unenforceable, because owner payment is not a condition precedent
G.S. 22C-2 says performance by a subcontractor entitles it to payment from the party with whom it contracts. Payment by the owner to the contractor is not a condition precedent to payment to the subcontractor, and an agreement to the contrary is unenforceable.
Reference: N.C. General Statutes Chapter 22C, G.S. 22C-2
A contractor's fixed overhead is $240,000 per year and each sales dollar contributes 25 percent after direct job costs. What annual revenue is needed to break even?
Answer: $960,000
Break-even revenue = fixed costs / contribution margin = $240,000 / 0.25 = $960,000. Check: 25 percent x $960,000 = $240,000. $60,000 multiplies instead of dividing.
Reference: General business and accounting practice, Break-even analysis
Activities: A (3 days, no predecessor); B (4 days, after A); C (2 days, after A); D (5 days, after B and C); E (3 days, after D). What is the minimum project duration?
Answer: 15 days
Path A-B-D-E = 3 + 4 + 5 + 3 = 15 days. Path A-C-D-E = 3 + 2 + 5 + 3 = 13 days. The longest path controls, so the project takes 15 days. Adding all durations gives 17, which ignores that B and C run in parallel.
Reference: General project management practice, Forward pass, critical path
A plumbing subcontractor last furnished labor at the site on March 4, 2026. What is the last day to file a claim of lien on real property under G.S. 44A-12(b)?
Answer: July 2, 2026
G.S. 44A-12(b) allows a claim of lien to be filed no later than 120 days after the last furnishing of labor or materials at the site. March 4 + 120 days = July 2, 2026 (27 days left in March, then 30 + 31 + 30 in April-June = 118, plus 2 days into July). June 2 counts only 90 days, and August 31 counts 180 days, which is the enforcement deadline in G.S. 44A-13(a).
Reference: N.C. General Statutes Chapter 44A, Article 2, G.S. 44A-12(b)
Sources
- PSI: NC Plumbing, Heating and Fire Sprinkler Contractors Candidate Information Bulletin (updated 8/25/2026) (opens in a new tab)
- NC State Board of Examiners of Plumbing, Heating and Fire Sprinkler Contractors (opens in a new tab)
- NC Board: 2024 code delay notice and exam book reference list (opens in a new tab)
Questions last verified November 14, 2026. Licensing rules change. Always confirm current requirements with the licensing agency before you apply.