Requirements at a glance
| Agency | New York State Department of State, Division of Licensing Services |
|---|---|
| Exam | The NYS written exam (2.5 hours, multiple choice, pass or fail) or the National Home Inspector Exam (NHIE) through PSI |
| Education | 140 hours of approved education (40 field hours) or 100 inspections |
| Fees | $50 NYS written exam; $250 license application |
| Insurance | Liability coverage of $150,000 per claim and $500,000 aggregate |
Applicants for a New York State home inspector license. This is the one trade license New York issues statewide. You pass either the NYS written exam or the NHIE, then apply to the Department of State.
How to get licensed, step by step
Complete your education or inspections
Finish the 140-hour pre-licensing course (40 hours in the field) or document 100 inspections.
NYS Department of State: become a home inspector (opens in a new tab)
Choose and pass an exam
Walk in to a Department of State exam center with photo ID, the $50 fee and two #2 pencils, or take the NHIE through PSI. Results are valid for two years.
NYS Department of State: become a home inspector (opens in a new tab)
Apply for the license
Send your original pass notice with the license application, the $250 fee and proof of insurance to the Department of State.
NYS Department of State: become a home inspector (opens in a new tab)
How to prepare
- The Department of State does not publish question counts or topic weights. Our practice bank follows its published topic list; the NHIE alternative is covered by our National Home Inspector Exam.
- License law and report writing are the New York specific parts; the rest is general inspection knowledge of structure, roofing, plumbing, electrical, heating and cooling, insulation and ventilation.
- Start with the free questions above to find your weak topics, then drill those first.
- Take at least two full timed simulations before exam day. Timing is where most people fail open-book exams.
- Read every explanation, including for questions you got right, and look the section up in your own book.
What to study
This is a closed-book exam, so nothing comes into the exam room. Study from these:
Official reference list (as published by the testing agency)
- NYS Department of State, Home Inspection Written Examination Information (July to December 2026)
- NYS Real Property Law Article 12-B (home inspector licensing), §§ 444-a to 444-q
- 19 NYCRR Part 197 (home inspector regulations, code of ethics and standards of practice)
- NHIE content outline (see our National Home Inspector Exam)
What's on the exam
Estimated topic weighting. No official breakdown is published:
| Topic | Questions | |
|---|---|---|
| License Law | 10 | |
| Report Writing | 10 | |
| Heating, Cooling and Plumbing Systems | 20 | |
| Insulation and Ventilation | 10 | |
| Structural, Exterior and Interior Components | 30 | |
| Electrical Systems | 20 |
Exam day details
- Administered by New York State Department of State, Division of Licensing Services (NHIE through PSI).
- Fee: $50 for the NYS written exam (check or money order or Visa/Mastercard, nonrefundable); the license application is $250. NHIE fees are paid to PSI.
- The NYS written exam is multiple choice and based on the 140-hour pre-licensing curriculum. Topics: license law; report writing; heating, cooling and plumbing systems; insulation and ventilation; structural, exterior and interior components; and electrical systems. You get 2.5 hours.
- Results are reported as pass or fail only, with no numerical score, and are valid for two years. Walk-in exams run at Department of State offices; bring photo ID, the $50 fee and two #2 pencils. No books or electronics.
- As an alternative you can pass the National Home Inspector Exam (NHIE) through PSI instead of the NYS written exam. Practice that content on our National Home Inspector Exam.
- Other requirements: 140 hours of approved education (40 of them field work) or 100 paid inspections, a $250 license application, and liability insurance of $150,000 per claim and $500,000 aggregate.
Note: The Department of State does not publish the number of questions, a pass mark or topic weights for its written exam. Our topic weights are estimates from the published topic list, and our 100-question, 70% quiz is a practice setting, not an official figure.
Frequently asked questions
Do I have to take the New York exam?
No. New York accepts either its own Department of State written exam or the National Home Inspector Exam (NHIE) from PSI. Practice the NHIE on our national exam page.
How is the New York home inspector exam scored?
Results are only pass or fail; no numerical score is given. The number of questions and a pass mark are not published, so our 100-question, 70% quiz is a practice setting.
Is home inspector licensing statewide in New York?
Yes. Unlike the trades, home inspectors are licensed by the NYS Department of State.
Free questions with answers
Show all 10 free questions and answers
While inspecting a gas furnace, you notice scorch marks on the sheet metal and melted wire insulation around the burner opening. What does this most likely indicate?
Answer: Flame rollout, which is a safety hazard
Flame rollout happens when flames escape the combustion chamber, often because flue gases cannot leave through a blocked vent or heat exchanger. It can start a fire and may also spill carbon monoxide, so the report should call it a safety hazard and refer it to an HVAC contractor. A dirty filter does not scorch the burner area.
Reference: NHIE Content Outline (EBPHI), Task 1.7: Heating systems
After the air conditioner has run for 25 minutes on a warm afternoon, your thermometer reads 76 degrees F at the return grille and 74 degrees F at a nearby supply register. What is the most appropriate way to report this?
Answer: A small temperature drop suggests poor cooling; recommend HVAC evaluation
A working air conditioner normally cools the air by well over a couple of degrees between the return and the supply; field rules of thumb put a normal split at roughly 15 to 20 degrees F. A 2 degree difference after 25 minutes of operation points to a cooling problem such as low refrigerant, poor airflow or a failing compressor. The inspector does not diagnose the cause: the NY standards do not require evaluating capacity or efficiency (197-5.11(b)(4)) or checking coolant pressure (197-5.11(b)(3)), but an observed reading this low is reported and the system referred to an HVAC contractor.
Reference: NHIE Content Outline (EBPHI), Task 1.6: Cooling systems
Under Article 12-B, which structure counts as a "residential building" that a licensed home inspector may inspect under the Act?
Answer: A previously occupied two-family house with an attached garage
Section 444-b(6) defines a residential building as a structure of one to four dwelling units and their garages and carports. It excludes any structure that is newly constructed or not previously occupied as a dwelling unit. A twelve-unit building is outside the definition.
Reference: NY Real Property Law Article 12-B (Home Inspection Professional Licensing Act), RPL 444-b(6)
The statutory definition of a home inspection in Article 12-B says that a home inspection does NOT include an inspection for which pair of conditions?
Answer: Radon or pests
Section 444-b(4) states that a home inspection shall not include an inspection for radon or pests. The inspector must still clearly identify in the written report which systems and components were observed. Other exclusions, such as hazardous substances and mold, appear in the standards of practice at 19 NYCRR 197-5.16, not in this definition.
Reference: NY Real Property Law Article 12-B (Home Inspection Professional Licensing Act), RPL 444-b(4)
Before you begin a home inspection in New York, what must you give the client under the code of ethics regulations?
Answer: A written pre-inspection agreement describing the scope of service and its cost
19 NYCRR 197-4.2(a) requires a written pre-inspection agreement that clearly and fully describes the scope of service and the cost before the inspection. The agreement must carry two required clauses printed in type not smaller than six point, and 197-4.2(b) requires the inspector to discuss the scope with the client and perform only services the client has authorized.
Reference: 19 NYCRR Part 197 (NY home inspector standards of practice), 19 NYCRR 197-4.2(a), (b)
In a client's attic, loose-fill insulation is piled against the roof deck at the eaves and covers the soffit vents. What is the correct finding?
Answer: Blocked eave ventilation; an air channel must stay open at the vent
Section R806.3 of the 2018 IRC (the base of the 2020 Residential Code of NYS; the 2021 IRC text is the same) says insulation must not block the free flow of air at eave or cornice vents and requires at least a 1-inch space between the insulation and the roof sheathing at the vent. Baffles are the usual way to keep the channel open. Blocked soffit vents reduce attic ventilation and can lead to moisture problems and ice dams.
Reference: 2018 International Residential Code (model code for the 2020 Residential Code of NYS), Section R806.3
A block foundation wall has a crack that steps diagonally along the mortar joints upward from a corner of the basement. What does this pattern most often indicate?
Answer: Differential settlement of part of the foundation
Stair-step cracking along mortar joints usually means one part of the foundation has settled more than the rest. The report should describe the crack, note any displacement and recommend evaluation by a qualified person if it is active or wide. Hollow cores do not by themselves point to termites.
Reference: NHIE Content Outline (EBPHI), Task 1.4: Structural components
A house is built on expansive clay soil. Which condition is most likely to be linked to that soil type?
Answer: Foundation movement as the clay swells and shrinks
Expansive clays change volume with moisture content, lifting and dropping the foundation through wet and dry seasons. Good drainage and consistent moisture around the foundation reduce the movement. The NY standards do not require the inspector to evaluate soil conditions (197-5.6(b)(3)), but the effect on the structure is reportable.
Reference: NHIE Content Outline (EBPHI), Task 1.4: Structural components; 19 NYCRR 197-5.6(b)(3)
At a panel's neutral bar, two white neutral conductors from different circuits share one terminal screw. Why is this reportable?
Answer: Each neutral needs its own terminal
Accepted electrical practice requires each grounded (neutral) conductor in a panelboard to end on its own terminal, not shared with another conductor. If the shared screw is loosened to work on one circuit, the other circuit loses its neutral, which can cause voltage problems and shock risk. The inspector reports it as a panel defect (19 NYCRR 197-5.9(a)(5)). Neutral color and the type of panel are not the issue.
Reference: NHIE Content Outline (EBPHI), Task 1.5: Electrical systems; 19 NYCRR 197-5.9(a)(5)
In the attic of an older house you find knob-and-tube wiring covered by loose-fill insulation. What is the main concern?
Answer: Covered by insulation, the wiring can overheat
Knob-and-tube was designed to cool in open air on porcelain supports and has no equipment grounding conductor. Covered by insulation it can overheat, and its old insulation is often brittle. The report should describe the wiring and recommend evaluation by an electrician.
Reference: NHIE Content Outline (EBPHI), Task 1.5: Electrical systems
Sources
Questions last verified November 15, 2026. Licensing rules change. Always confirm current requirements with the licensing agency before you apply.