Requirements at a glance
| Agency | Alabama Board of Heating, Air Conditioning and Refrigeration Contractors (HACR); exam by Prov |
|---|---|
| Exam | 115 questions, 5 hours, 70% to pass, open book |
| Books allowed | 2021 IRC, 2020 NEC, ACCA Manual D and Manual J, Refrigeration and Air Conditioning Technology (9th), a duct calculator, NASCLA Contractors Guide (14th) and the HACR laws and rules |
| Fee | $175 to the Board with your application; Board license fees are separate |
Anyone applying for an Alabama heating and air conditioning (HAC) contractor license from the Board of Heating, Air Conditioning and Refrigeration Contractors. Alabama has no state journeyman HVAC exam.
Official links
How to get licensed, step by step
Meet the eligibility requirement
The Board accepts 2 years of apprentice registration, 3,000 hours of experience or an approved curriculum.
Alabama Board of Heating, Air Conditioning and Refrigeration Contractors (opens in a new tab)
Apply to the board
Send the Board your application and the $175 exam fee. A new approval is required before each attempt.
Alabama Board of Heating, Air Conditioning and Refrigeration Contractors (opens in a new tab)
Schedule with Prov
Once the Board approves you, register and schedule your exam. Prov grades the exam right away and sends your result to the board. If you fail, wait 30 days before retesting.
Bring your references
All of these exams are open book. Bring the exact books the bulletin lists; permanent tabs and pen highlighting are allowed, sticky notes and loose notes are not.
How to prepare
- Systems and sizing is 25 of 115 questions. Practice a Manual J load calculation and a Manual D duct sizing with your ductulator.
- About 31 questions are business and law (licensing laws, estimating, payroll, contracts). The NASCLA guide covers them.
- Electrical applications for HAC systems (10) use the 2020 NEC: tab the motor, transformer and conductor sizing articles.
- Start with the free questions above to find your weak topics, then drill those first.
- Take at least two full timed simulations before exam day. Timing is where most people fail open-book exams.
- Read every explanation, including for questions you got right, and look the section up in your own book.
Books for this exam
This is an open-book exam: you can bring the references below. Tabs and highlighting are allowed. Free online copies are read-only and can't be used in the exam room.
Official reference list (as published by the testing agency)
- International Residential Code (IRC), 2021 edition (allowed in the exam room)
- NFPA 70, National Electrical Code (NEC), 2020 edition (allowed in the exam room)
- ACCA Manual D: Residential Duct Systems, Version 2.5 (allowed in the exam room)
- ACCA Manual J (Residential Load Calculation, Abridged), 8th Edition (allowed in the exam room)
- Refrigeration and Air Conditioning Technology, 9th Edition, Cengage (allowed in the exam room)
- Trane Ductulator (2013) or ACCA ductulator (allowed in the exam room)
- NASCLA Contractors Guide to Business, Law and Project Management, 14th Edition (allowed in the exam room)
- Laws, Rules and Regulations of the State of Alabama (Board of HACR), 2009; printed candidate copies are allowed (allowed in the exam room)
What's on the exam
Official content outline from Prov, Inc. (number of questions per topic):
| Topic | Questions | |
|---|---|---|
| General Knowledge | 12 | |
| Piping | 11 | |
| Systems and Sizing | 25 | |
| Equipment | 12 | |
| Maintenance | 11 | |
| Plan Reading | 3 | |
| Business Organization | 3 | |
| Risk Management | 3 | |
| Project Management | 2 | |
| Estimating | 3 | |
| Safety and Environmental | 3 | |
| Labor Laws | 3 | |
| Payroll and Employment Taxes | 3 | |
| Financial Management | 3 | |
| Contracts | 3 | |
| Lien Laws | 2 | |
| Licensing Laws | 3 | |
| Electrical Applications for HAC Systems | 10 |
Exam day details
- Administered by Prov, Inc. for the Alabama Board of Heating, Air Conditioning and Refrigeration Contractors.
- Fee: $175 to the Board of Heating, Air Conditioning and Refrigeration Contractors with your application. Board license fees are separate.
- 115 questions in 5 hours; 70% to pass.
- Eligibility per the Board's application: 2 years of apprentice registration, 3,000 hours of experience, or an approved curriculum. Licenses cost $220 a year and need a $20,000 bond.
- The bulletin pairs the 2021 IRC with the 2020 NEC; our questions follow the editions the bulletin lists.
- Prov gives the exam; the exam fee is paid to the Board. A new Board approval is required before each attempt and you wait 30 days to retest.
- Alabama has reciprocity with MS, TN, OH, SC, TX, WV and LA.
Frequently asked questions
What's on the Alabama HVAC contractor exam?
115 questions: systems and sizing 25, general knowledge 12, equipment 12, piping 11, maintenance 11, electrical applications 10, plan reading 3, plus about 31 business and law questions (licensing laws, estimating, payroll, contracts and more).
Is there an Alabama journeyman HVAC exam?
No. The state exam is for the contractor license; apprentices register with the Board.
Does it cover refrigeration?
No. Refrigeration contractors take a separate Alabama exam.
Free questions with answers
Show all 10 free questions and answers
What is the minimum level working space that must be provided in front of the control side of a furnace or other appliance that needs servicing?
Answer: 30 inches deep by 30 inches wide
IRC Section M1305.1 requires a level working space at least 30 inches deep and 30 inches wide in front of the control side of an appliance. The 24-inch figure is the minimum width of the passageway to an appliance in a room, not the service space; 36 and 18 inches do not appear in this requirement.
Reference: 2021 International Residential Code, M1305.1
A down-flow air handler has no provision for a secondary drain or auxiliary pan. Where must the water-level monitoring device be installed?
Answer: Inside the primary drain pan itself, not in the drain line
IRC M1411.3.1.1 says that on down-flow units and other coils with no secondary drain or provision for an auxiliary pan, a water-level monitoring device must be installed inside the primary drain pan to shut off the equipment if the primary drain becomes restricted, and devices shall not be installed in the drain line.
Reference: 2021 International Residential Code, M1411.3.1.1
Refrigerant circuit access ports located outdoors, such as on a condensing unit at the side of a building, must be fitted with what?
Answer: Locking-type tamper-resistant caps or be otherwise secured
IRC M1411.9 requires refrigerant circuit access ports located outdoors to be fitted with locking-type tamper-resistant caps or otherwise secured to prevent unauthorized access. Dust caps, labels or soldered plugs do not meet the rule.
Reference: 2021 International Residential Code, M1411.9
A new 1,800-square-foot single-family house has 3 bedrooms. Using IRC Equation 15-1, Q = 0.01 x Afloor + 7.5 x (Nbr + 1), what is the minimum continuous whole-house mechanical ventilation rate?
Answer: 48 cfm
0.01 x 1,800 = 18 cfm; 7.5 x (3 + 1) = 30 cfm; 18 + 30 = 48 cfm. 18 cfm omits the bedroom term, 40.5 cfm uses 3 instead of Nbr + 1, and 55.5 cfm uses Nbr + 2. (M1505.4.3 also allows Table M1505.4.3(1) instead of the equation.)
Reference: 2021 International Residential Code, M1505.4.3, Equation 15-1
A technician has recovered R-410A from a customer's system. Where may that recovered refrigerant be reused without reclaiming?
Answer: Only in the same system or other systems of the same owner
40 CFR 82.156(h) lets recovered refrigerant be returned to the appliance it came from, or to another appliance owned by the same person, without being recycled or reclaimed (except MVAC). Under 82.154(d), used refrigerant may not be sold or distributed for use by another party unless reclaimed by a certified reclaimer. Filtering or drying does not make it usable in another customer's equipment.
Reference: 40 CFR Part 82, Subpart F, 82.156(h) and 82.154(d)
On a mechanical plan drawn at 1/4 inch = 1 foot, the passageway from an attic access opening to a furnace measures 5 inches along its centerline. What is the actual length, and does it meet the standard IRC attic passageway limit of 20 feet?
Answer: 20 feet; it meets the limit
5 in / 0.25 in per foot = 20 feet. M1305.1.2 limits an attic passageway to not more than 20 feet along the centerline unless the exception for a 6-foot-high, 22-inch-wide passageway (50 feet) applies, so 20 feet is allowed. Using 1/2 inch = 1 foot would give 10 feet; using 1/8 inch = 1 foot would give 40 feet.
Reference: 2021 International Residential Code, M1305.1.2
An insulated 10 AWG equipment grounding conductor to a condensing unit must be identified how?
Answer: Continuous green, or green with one or more yellow stripes
NEC 2020 250.119 requires individually covered or insulated equipment grounding conductors to have a continuous outer finish that is green or green with one or more yellow stripes (field re-identification under 250.119(A) applies only to conductors 4 AWG and larger). White or gray identifies the grounded conductor.
Reference: 2020 National Electrical Code (NFPA 70), 250.119
Which situation requires certification by the Board under rule 440-X-3-.02, so that doing the work uncertified would be a licensing risk?
Answer: Air duct cleaning or equipment cleaning services
Rule 440-X-3-.02(3) requires Board certification for air duct cleaning, filter changing, test and balance and the cleaning of heating, air conditioning or refrigeration equipment or systems. Retail sellers who do not install are exempt under .05(1).
Reference: Alabama Administrative Code, Board of HACR Contractors, 440-X-3-.02(3); 440-X-3-.05(1)
Which statement describes the person in responsible charge of an HVAC business entity under rule 440-X-3-.09(1)?
Answer: A W-2 employee, owner, partner or officer averaging 30+ hours a week
Rule 440-X-3-.09(1) requires the person in responsible charge to be a regularly employed person (an actual W-2 employee, not an independent contractor) averaging 30 or more hours per week, who may also be an owner, partner or corporate officer, and who supervises and controls the installation, service or repair activities.
Reference: Alabama Administrative Code, Board of HACR Contractors, 440-X-3-.09(1); 440-X-1-.01(13)
Direct cost for a job is $4,200 in material plus 60 labor hours at a burdened $38 per hour. Overhead is 15 percent of direct cost and profit is 10 percent of cost plus overhead. What is the bid price?
Answer: $8,197
Direct cost = 4,200 + 60 x 38 = 4,200 + 2,280 = $6,480. Overhead 15 percent = $972, so cost plus overhead = $7,452. Profit 10 percent of $7,452 = $745.20. Bid = $8,197.20. $7,452 omits profit; $8,100 adds 25 percent to direct cost alone; $8,424 adds 30 percent of direct cost.
Reference: NASCLA Contractors Guide to Business, Law and Project Management, 14th ed. (concept; textbook not on disk), Concept: estimating with overhead and profit
Sources
- Prov: Alabama Board of HACR Candidate Information Bulletin (opens in a new tab)
- Alabama Board of Heating, Air Conditioning and Refrigeration Contractors (opens in a new tab)
Questions last verified November 17, 2026. Licensing rules change. Always confirm current requirements with the licensing agency before you apply.